CONTROL CARD-2 W/ EPM R4.3 clei The Control Card 2 implements the control complex functions for the node. The Control Card 2 provides two RS-232 ports node management (local and/or remote NMTI), and one Ethernet 10BaseT interface port for network management system access. One Control Card is required for non-redundant control complex and two for control complex redundancy per 36170 system. Node management, alarm, and timing termination require a control card interconnect panel (CCIP). One CCIP serves both active and redundant control cards. There are two variants of CCIP for US Telco (90-2295-x1) and International (90-2295-x2) requirements. This card is delivered with R4.3 software, and with an enhanced Processor Module (ePM), and with a NAND-based 256MB memory card. Note that previous to this note, all control cards were shipped wih NOR-based memory cards. The software loadset required for this card is documented in Field Notice FN1867. This assembly contains a Telcordia CLEI (Common Language Equipment Identifier) label.