Consumable kit for 2 installations sites

CONTROL AND GENERAL I/F

CONTROL AND GENERAL I/F

CONTROL AND GENERAL I/F

CONTROL AND GENERAL I/F

CONTROL AND GENERAL I/F

CONTROL AND GENERAL I/F (2 WIRES / 384W / 10A / W/O FAN SUPERVISION)

CONTROL AND GENERAL I/F (2 WIRES / 384W / 10A / W/O FAN SUPERVISION)

CONTROL AND GENERAL I/F (2 WIRES / 960W / 25A / WITH FAN SUPERVISION)

CONTROL AND GENERAL I/F (2 WIRES / 960W / 25A / WITH FAN SUPERVISION)

CONTROL CARD

CONTROL CARD 2

CONTROL CARD 2 R4.3 clei The Control Card 2 implements the control complex functions for the node. The Control Card 2 provides two RS-232 ports node management (local and/or remote NMTI), and one Ethernet 10BaseT interface port for network management system access. One Control Card is required for a non-redundant control complex and two for control complex redundancy per 36170 system. Node management, alarm, and timing termination require a control card interconnect panel (CCIP). One CCIP serves both active and redundant control cards. There are two variants of CCIP for US Telco (90-2295-x1) and International (90-2295-x2) requirements. This card is delivered with R4.3 software. This assembly contains a Telcordia CLEI (Common Language Equipment Identifier) label.

CONTROL CARD-2 W/ EPM R4.3 clei The Control Card 2 implements the control complex functions for the node. The Control Card 2 provides two RS-232 ports node management (local and/or remote NMTI), and one Ethernet 10BaseT interface port for network management system access. One Control Card is required for non-redundant control complex and two for control complex redundancy per 36170 system. Node management, alarm, and timing termination require a control card interconnect panel (CCIP). One CCIP serves both active and redundant control cards. There are two variants of CCIP for US Telco (90-2295-x1) and International (90-2295-x2) requirements. This card is delivered with R4.3 software, and with an enhanced Processor Module (ePM), and with a NAND-based 256MB memory card. Note that previous to this note, all control cards were shipped wih NOR-based memory cards. The software loadset required for this card is documented in Field Notice FN1867. This assembly contains a Telcordia CLEI (Common Language Equipment Identifier) label.

CONTROL CARD-2 W/EPM clei The Control Card 2 with enhanced Processing Module (ePM) implements the control complex functions for the node. The Control Card 2 provides two RS-232 ports node management (local and/or remote NMTI), and one Ethernet 10BaseT interface port for network management system access. One Control Card is required for a non-redundant control complex and two for control complex redundancy per 7470 system. Node management, alarm, and timing terminations require a control card interconnect panel (CCIP). One CCIP serves both active and redundant control cards. There are two variants of CCIP for US Telco (90-2295-x1) and International (90-2295-x2) requirements. Note that this card is not supported in Release 8.0 and above - only the Integrated Control Card (90-6226-xx) is supported in Release 8.0 and above systems.

CONTROL MODULE VR 6

Cord E1/DS1 RJ45 to RJ45 crossover L:5m

Cord E1/DS1 RJ45 to wire-wrap L:2m

Cord E1/DS1 RJ45 to wire-wrap L:5m

Cord IDU/IDU protec cable RJ45/RJ45 0.2m